Table of Contents
Advertisement
Shaping Small Stock
ALWAYS use hold-downs or featherboards
and push sticks when shaping small or nar-
row stock. These devices keep your hands
away from the spinning cutter and suffi-
ciently support the stock to allow a safe and
effective cut, reducing the risk of personal
injury.
To make a zero-clearance fence:
1.
2.
3.
The Model G9933 shaper is
designed to be used with
only one motor operating
at a time. Attempting to
have more than one oper-
ator using this machine at
the same time may lead to
an overload or cause seri-
ous personal injury due
to unsafe working condi-
tions.
4.
Figure 33
Note: Make the outline as close as possible
to the cutter and spindle without interfering
with rotation.
Figure 33.
5.
6.
Step 3
Advertisement
Table of Contents
