Table of Contents
Advertisement
Figure 15.
3.
Dust Collection
DO NOT operate the Model G9933 without
an adequate dust collection system. This
shaper creates substantial amounts of wood
dust while operating. Failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended CFM at
Each Dust Port: ...............................400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Troubleshooting
Figure 15
Before starting the shaper, make sure you
have performed the preceding assembly
instructions, and you have read through the
rest of the manual and are familiar with the
various functions and safety features on
this machine. Failure to follow this warning
could result in serious personal injury or
even death!
To test run the machine:
1.
2.
Test Run
Page 39
ON
Advertisement
Table of Contents
