Table of Contents
Advertisement
Installing Cutter
Tools Needed
To install a cutter:
1.
2.
3.
Figure 25
Figure 25.
4.
Qty
Figure 26.
5.
Note: The goal in the next steps is to install
the cutter and spacers in a configuration that
will keep the cutter as low as possible on the
spindle. Also, make sure the spindle nut is
slightly higher than the spindle when it is fully
tightened down so that the locking hex bolt
and flat washer can apply locking pressure to
the nut and not the spindle, as illustrated in
Figure 27
Figure 27.
Figure 26
Advertisement
Table of Contents
