Table of Contents
Advertisement
5.
Figure 30.
Note: To reduce the effects of tearout, cut the
end grain first when putting an edge around
the perimeter of a workpiece, as illustrated in
Figure 31.
Figure 31.
The sound of this shaper when it is running
may be less than other devices that are in
operation, such as a dust collector. Because
of this, it may be difficult to determine if the
shaper is running merely by listening. To
avoid serious personal injury, you MUST
make certain the shaper is turned OFF and
is disconnected from power before attempt-
ing any setup or adjustments.
Figure 30
Cutting Rabbets
Figure 32.
To make a rabbet cut:
1.
2.
Figure 32
Note: To ensure good results for heavy cuts,
make multiple light passes and raise the cut-
ter a small amount for each pass.
3.
Figure 32
4.
ON
Figure 32
Advertisement
Table of Contents
