Table of Contents
Advertisement
Edge Cutting
Because the fence may not always be per-
fectly parallel to the table miter slot, using
the miter gauge could cause the workpiece
to bind and kickback toward the operator.
DO NOT use the miter gauge to feed the
workpiece along the fence when straight
shaping. Use a push sticks and hold-downs
to keep the workpiece in position.
Full Edge Cutting
1.
2.
3.
4.
5.
6.
7.
8.
Figure 29
Figure 29.
9.
Partial Edge Cutting
1.
2.
3.
4.
Advertisement
Table of Contents
