Kenwood NX-1000 Series User Manual page 74

If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1 Press and hold the button programmed as [Emergency].
• Depending on the delay time programmed into your transceiver, the length
of time you must hold the Emergency button will vary.
• When the transceiver enters Emergency mode, the transceiver will change
to the Emergency channel and begin transmitting based on how the
transceiver is set up by your dealer. Transmit periods are also set by your
dealer.
2 To exit Emergency mode, press and hold the [Emergency] button again.
• If the Emergency mode completes a preset number of cycles, Emergency
mode will automatically end and the transceiver will return to the zone and
channel that was in use before Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when Emergency mode
starts and stops.
◆ Your dealer can set the transceiver to emit tones and received signals as
normal or mute the speaker during Emergency operation.
EMERGENCY CALLS
74