Kenwood NX-1000 Series User Manual page 38

GPS Position Display
This is the function to show the location information of the own transceiver on the
transceiver display.
PF Button:
Press the programmed button to the displayed in the order of latitude (5 sec) ,
longitude (5 sec) , altitude (5 sec) , latitude (5 sec) ... .
Menu Mode:
1
Select "
GPS DISP
2 Press the [ <B ] and [ C> ] buttons to the displayed in the order of latitude,
longitude, altitude, latitude...
latitude
longitude
altitude
3 Press the [ S ] button to confirm and exit mode.
Note:
◆ Whether to show the latitude and longitude depends on the configuration in
Latitude and Longitude.
◆ Whether to show the altitude depends on the configuration in Altitude.
◆ If the configurations in Latitude and Longitude and Altitude are both disabled,
the transceiver cannot enter GPS Position Display Mode.
◆ If Mode Reset Timer is configured, GPS Position Display Mode is terminated
after the time configured in Mode Reset Timer elapses.
[Analog/ NXDN/ DMR]
" and press the [ S ] button.
38