Initial Terminal Setup; Using The Setup Wizard - HP Compaq t1000 Supplementary Manual

3

Initial Terminal Setup

The Setup Wizard is used for initial setup of the terminal's properties. The wizard
runs when:
• You power-up your terminal for the first time.
Your terminal has been restarted with a G key reset.
•
• A new image has been downloaded to your terminal but is older than the image
currently in use.
You use the Reset the Terminal to Factory-Default Property Settings
•
function on the General properties sheet.

Using the Setup Wizard

The Setup Wizard lets you set terminal network configuration and terminal display
parameters. There are six dialog boxes that display in succession during the
process. Each dialog box is self-explanatory. Some dialog boxes are informational
and require no user input. Other dialog boxes will prompt you for network and
display information. See Figure 3-1 to view the first dialog box of the wizard.
Note
Any future changes can be made using the Terminal
Properties dialog box. You can launch this dialog box
from the T1000 Connection Manager by pressing the
F2 key. See "Resetting Terminal Properties."