HP Compaq t1000 Supplementary Manual page 188

158
Firmware Upgrades
3. Using the SNMP/Network Administrator dialog box, verify that the community
and set community names for the terminal match the community and set
community names in the SNMP manager.
4. Using your SNMP manager:
a. Go to 1.2.3.8.1.2 (wbt3UpDnLoadTable).
b. Go to 1.2.3.8.1.2.1.2 (wbt3UpDnLoadID), user defined string.
c. Go to 1.2.3.8.1.2.1.3 (wbt3UpDnLoadOp), and set its value to
d. Go to 1.2.3.8.1.2.1.4 (wbt3UpDnLoadSrcFile), and set its value to the
e. Go to 1.2.3.8.1.2.1.6 (wbt3UpDnLoadFileType), and set its value to 0
f. Go to 1.2.3.8.1.2.1.7 (wbt3UpDnLoadProtocol), and set its value to 0 or 1
g. Go to 1.2.3.8.1.2.1.8 (wbt3UpDnLoadFServer), and set its value to the IP
h. Go to 1.2.3.8.1.4 (wbt3SubmitLoadJob), and set its value to
Step 4h will initiate an SNMP upgrade to your terminal. If the download is
configured properly, the new image will download and the terminal will reboot
automatically to factory defaults.
Refer to Chapter 29, FTP Pull Firmware Upgrades, to view the dialog boxes that
display during the process.
Note
You can set the Set Community name for a terminal if
you have DHCP enabled by setting DHCP Option 164
to the set community name your SNMP manager uses.
Note
The above is used in traps to identify the download
operation.
1 (Download).
absolute path of the directory where the image file and params.ini are
located.
(Binary).
(FTP or TFTP).
address or DNS name of the FTP or TFTP server.
1 (Ready).