Mounting The Terminal - HP Compaq t1000 Supplementary Manual

10
Terminal Installation
Proceed as follows to connect the terminal:
1. Connect the monitor to the Video connector.
2. Connect the keyboard to the Keyboard connector.
3. Connect the mouse to the Mouse connector.
4. If you will be using a network connection, connect a CAT5 UTP cable to the
Network connector. Depending on your configuration needs, connect a printer
to the parallel port and/or connect a modem/server serial cable to the serial
ports, as appropriate.
5. Connect the power supply output cable to the Power connector.
6. Plug the AC cord into the power supply, then into an AC outlet.
7. After the cables are connected, install the terminal in its planned location, either
on a desktop or mounted to a wall (see the next section "Mounting the
Terminal").

Mounting the Terminal

The terminal can be freestanding, attached to a wall (an optional wall mount kit is
required), or mounted permanently on a desktop. Instructions for mounting your
terminal are provided in the following paragraphs; use the instructions that are
appropriate for the desired method of mounting your terminal.
Note
Before connecting the cables, decide which mounting
configuration will be used and ensure that the cables
are of the correct lengths. If permanent desktop or
wall-mounting configuration is to be used, drill the
desktop mounting holes or install the mounting bracket
wall anchors before connecting the cables.
Caution
Do not force a connector into its socket. If any undue
resistance is encountered, ensure that the connector is
oriented correctly to the socket.