Removing The Small Access Panel - HP Compaq 6000 Install Manual

2-6 Hardware Upgrades

Removing the Small Access Panel

To remove and replace the small access panel:
1.
2.
3.
4.
5.
6.
tulan003.EPS
Figure 2-2.
If the workstation is on, turn it off and disconnect the power cord.
Disconnect any other external equipment.
Open the front bezel.
Loosen the thumbscrew above the speaker.
Slide the small access panel toward the rear of the unit about
0.5 inch (1.5 cm), and then slide the panel to the side of the workstation.
Lift and remove the panel.
CAUTION:
panel removed. The small access panel is an integral part of the
cooling system and removing it while the system is running may
adversely affect data integrity.
Removing the small access panel and the large access panel
Do not operate the workstation with the small access