Network Problems - HP Compaq 6000 Install Manual

Network Problems

Problem
Setup utility does
not detect a
network controller.
Setup utility
reports
unprogrammed
EEPROM.
Table 8-7
Network Problems and Solutions
Possible Cause
Possible I/O address conflict
with another expansion
board.
Possible I/O address conflict
with another expansion
board.
The network controller is
defective.
Network drivers are not
loaded.
Compaq Professional Workstation 6000 and 8000 Reference Guide
Possible Solution
Either remove and reconfigure
the conflicting expansion board,
or reconfigure the network
controller. If the address is
changed, ensure that the drive
parameters match the new I/O
address for the network
controller.
Either remove and reconfigure
the conflicting expansion board,
or reconfigure the network
controller. If the address is
changed, ensure that the drive
parameters match the new I/O
address for the network
controller.
Contact your Compaq authorized
service provider.
Boot the workstation without the
network drivers, using a system
boot diskette, and reconfigure the
network controller.
8-11
continued