HP Compaq 6000 Install Manual page 128

E-2 Error Messages
POST Error Messages and Codes
172-1 Configuration
Nonvolatile Memory
Invalid
201-Memory Error
202-Memory Type
Mismatch
203-Memory
Address Error
205-Memory
Error
207-ECC Corrected
Single Bit Errors in
DIMM/SIMM Pair(s)
210-Invalid Memory
Configuration
Detected. Maximum
of 512 MB of
Memory Supported.
System Halted.
Error Code
NVRAM Configuration
Error
RAM failure.
RAM failure
RAM failure.
Cache memory error.
A memory error on one
of the installed DIMMs
has been detected and
corrected with the
system's ECC logic. The
workstation will
continue to operate
correctly with this error.
RAM failure
(Professional
Workstation 6000 only).
continued
Probable Source
of Problem Action
Allow system to complete
boot. Reboot.
If condition persists, contact
your Compaq authorized
service provider.
Contact your Compaq
authorized service provider.
Contact your Compaq
authorized service provider.
Contact your Compaq
authorized service provider.
Run the Computer Checkup
or Diagnostics utility.
Run Diagnostics to get more
information; then contact
your Compaq authorized
service provider.
Remove memory from
system until total amount is
less than 512 MB.
continued