HP Compaq 6000 Install Manual page 30

CAUTION:
components of the workstation or optional equipment. Before
beginning these procedures, ensure that you are discharged of
static electricity by briefly touching a grounded metal object. See
Appendix D for more information.
IMPORTANT: Do not place anything on power cords or cables. Arrange
them so that no one may accidentally step on or trip over them. Do not pull on
a cord or cable. When unplugging from the electrical outlet, grasp the cord by
the plug.
1. If the workstation is already on, turn it off and disconnect the power
cord from the wall outlet.
2. Open the workstation by removing the outside panels and front bezel.
See the sections "Removing the Small Access Panel," "Removing the
Large Access Panel," and "Removing the Front Bezel" in this chapter
for instructions.
3. Install any optional equipment (ISA or PCI expansion board, processor
upgrade, memory, or drive). Refer to the applicable sections of this
manual or the documentation provided with the option kit
for instructions.
4. Replace the front bezel, large access panel, and small access panel.
5. Plug the power cord into a grounded AC outlet.
6. Turn on the monitor, workstation, and any devices you want to test.
7. Reconfigure the workstation, if necessary. See Chapter 4 for
instructions.
8. Test the workstation (optional) using the TEST utility.
Static electricity can damage the electronic
Compaq Professional Workstation 6000 and 8000 Reference Guide
2-3