HP Compaq 6000 Install Manual page 44

Installing DIMM Modules
This section provides an overview of DIMM installation. For complete
installation procedures, refer to the documentation included with the option kit.
IMPORTANT: Prior to installing a DIMM, read the important guidelines in the
previous section.
To install a DIMM:
1. If the workstation is on, turn it off and disconnect the power cord.
2. Disconnect any other external equipment.
3. Unlock and open the front bezel.
4. Remove the following components:
large access panel
security screw
processor cage
5. Place the processor cage on a flat surface and open the cage.
6. If adding DIMMs to the memory expansion board, remove the board and
place it, component side up, on a flat, static-dissipating surface.
7. Open the appropriate DIMM socket latches.
8. Align the key slot on the bottom edge of each DIMM with the tab in the
DIMM socket.
Compaq Professional Workstation 6000 and 8000 Reference Guide
2-17