Programming Console Operations; Overview - Omron Sysmac CPM1 Operation Manual

Programming Console Operations

4-3

Programming Console Operations

4-3-1 Overview

Name
Clearing memory
Reading/clearing error
messages
Buzzer operation
Setting a program
memory address
Reading a program
memory address
Instruction search
Bit operand search
Inserting and deleting
instructions
Entering or editing
programs
Checking the program
Bit, digit, word monitor
Multiple address
monitor
Differentiation monitor
Binary monitor
3-word monitor
Signed decimal
monitor
Unsigned decimal
monitor
3-word data
modification
Changing timer,
counter SV 1
Changing timer,
counter SV 2
Hexadecimal, BCD
data modification
Binary data
modification
Signed decimal data
modification
Unsigned decimal data
modification
Force set/reset
Clear force set/reset
Hex-ASCII display
change
Displaying the cycle
time
The following table lists the programming and monitoring operations that can be
performed from a Programming Console. Refer to the rest of this section for
details on operational procedures.
Clears all or part of the Program Memory and any data areas that are not read-only, as well
as the contents of the Programming Console's memory.
Displays and clears error messages and displays MESSAGE instruction messages.
Turns on and off the buzzer that sounds when Programming Console keys are pressed.
Sets the specified program memory address when reading, writing, inserting and deleting
programs.
Reads the contents of the Program Memory. Displays the status of the currently displayed bit
in PROGRAM and MONITOR modes.
Finds occurrences of the specified instruction in the program.
Finds occurrences of the specified operand bit in the program.
Inserts or deletes instructions from the program.
Overwrites the contents of the current Program Memory to either input a program for the first
time or to change a program that already exists.
Checks for programming errors and displays the program address and error when errors are
found.
Monitors the status of up to 16 bits and words, although only 3 can be shown on the display
at one time.
Monitors the status of up to 6 bits and words simultaneously.
Monitors the up or down differentiation status of a particular bit.
Monitors the ON/OFF status of any word's 16 bits.
Monitors the status of three consecutive words.
Converts the contents of the specified word from signed hexadecimal (two's complement
format) to signed decimal for display.
Converts hexadecimal data in a word to unsigned decimal for display.
Changes the contents of one or more of the 3 consecutive words displayed in the 3-Word
Monitor operation.
Changes the SV of a timer or counter.
Makes fine adjustment changes to the SV of the timer or counter.
Changes the BCD or hexadecimal value of a word being monitored.
Changes the status of a word's bits when the word is being monitored.
Changes the decimal value of a word being monitored as signed decimal data, within a
range of –32,768 to 32,767. The contents of the specified word are converted automatically
to signed hexadecimal (two's complement format.)
Changes the decimal value of a word being monitored as unsigned decimal data, within a
range of 0 to 65,535. A change into hexadecimal data is made automatically.
Forces bits ON (force set) or OFF (force reset.)
Restores the status of all bits which have been force set of reset.
Converts word data displays back and forth between 4-digit hexadecimal data and ASCII.
Displays the current average cycle time (scan time.)
Function
Section 4-3
59