Signal And Port Settings For External Equipment - Furuno FAR-3320-NXT Instruction Manual

4. Click the [Details] button to open the [Details Setting] window and enter the appro-
priate items.
5. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4.7

Signal and Port settings for external equipment

This connection setting menu can set the serial I/O for external equipment, the analog
input for sensor adapter, and HUB port.
1. Click [Connection Setting] on the menu bar.
2. Click [Serial Input/Output Setting] on the menu bar.
The serial input/output settings are shown. The settings can be changed, referring
to step 6 of section 1.4.2.
3. Click [Analog Input Setting] on the menu bar.
The serial input/output settings are shown. The settings can be changed, referring
to step 12 of section 1.4.4.
1. INITIAL SETTING AND ADJUSTMENT
• [Equipment Name]: Enter the name of the
HUB.
• [IP Address]: Select the network and IP Ad-
dress of the HUB from the pull-down list.
• [Community]: Set the parameters for SNMP
protocol. This setting must be the same as set
at the HUB.
1-29