Connection Of Video Equipment/External Monitor/Remote Display - Furuno MARINE RADAR 1823C Installation Manual

4.2 Connection of Video equipment /
External Monitor/Remote Display
The above units can be connected to the MODEL1823C/1833C/1933C/1943C/1953C and
GD-1900C by using the hole at the rear of the display unit. Remove the cover to use this
hole. After connecting, cover the hole with soft putty to seal.

Connection of Video equipment/External monitor/remote display

4.2.1 Connecting video equipment
The display unit can show the picture from the CCD camera, video recorder etc. which
outputs composite signal in NTSC/PAL format, by using the optional NTSC/PAL interface kit.
Necessary parts
Name: NTSC/PAL Interface kit
Type: OP03-175
Code no.: 008-523-070
Name
PIP board
Pan head screw
Connector assy
Cable tie
Rubber grommet
4-4
Video recorder, CCD camera etc.
Remote display (ex. FMD-811)
Table 4-2 NTSC/PAL Interface kit contents
Type
19P1004
M3x6 C2700W
RCA-TMP-L230
SG-130
MG-4
12:00
VGA monitor
Code No.
008-521-890
000-881-403
000-144-615
000-809-171
000-871-378
CAUTION
Even though the display
unit meets waterproof
standard IPX-5,
this modification can
affect waterproofness.
Watertight integrity
cannot be guaranteed.
Qty Remarks
NTSC/PAL
1
interface Board
4
1
3 w/foot for fixing
1