How To Delete An Alert Group; Alert Definition Setting For Each Equipment - Furuno FAR-3320-NXT Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
1.8.4

How to delete an alert group

1. Click the [Delete Group] button on the [Alert Group Setting] window, referring to
the figure in step 2 of subsection 1.8.1. The list of the alert groups is shown in the
[Group Details] window.
Checkbox
2. Check the checkbox of the alert group to delete. To delete all groups, check the
"Delete All" box.
3. Click the [OK] button.
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.8.5

Alert Definition setting for each equipment

You can create alert definitions and activate/deactivate the alert(s) for each external
equipment or sensor.
1. Access the [Common Installation Setting] menu, then select [Alert Define List]
from the Tab bar.
2. Select the appropriate type on the menu bar. For example, select [Chart Radar]
 [FAR-3xx0] to set the alert definitions for FAR-3xx0.
Note: The equipment and sensors shown on the menu bar depend on the [Instal-
lation Parameters] menu settings.
3. Set the appropriate options referring to the table shown below.
1
2
3
4
1-44
Delete All
box
Item
Equipment type Selected equipment type.
[Source] Define the category to which the alert is assigned for dis-
play in the AMS mode's alert list window ([Navigation],
[Communication] or [External]).
[Data Type] Alert sentence format (ALF or ALR). For sensors, select
the alert notification sentence from the pull-down list.
[New Alert] but- Add a new alert definition. See section 1.8.6.
ton
Remarks