Factory Test & Default] Menu - Furuno FAR-3320-NXT Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
1. For LAN connection, connect the USB memory which has the update file to the
PC connected via LAN. For access with the control unit, insert the update DVD in
the processor unit's DVD drive.
2. Access the [Common Installation Setting] menu and click [Software Update] on
the tab menu.
For the IP address of the unit to update, see the Equipment ID list at the back of
this manual.
3. Select the unit to update from the menu bar.
4. Click [Select File] to select the update, and then click [OK].
The current software version and updated software version are displayed.
5. Check the checkbox for the software to update.
6. Click [Update Software]. A confirmation message appears.
7. Click [OK] to update the software.
The progress bar shows the update progress. After completing the update, the
system is automatically rebooted.
8. If connected to the gateway network, the link is shown on the display after com-
pleting the system reboot. Click the link on the display to access the [Common In-
stallation Setting] menu.
If connected to the sensor network, enter the IP address of the sensor network
to access the [Common Installation Setting] menu after completing the system re-
boot.
1.14 [Factory Test & Default] Menu
The [Factory Test & Default] menu does the factory test to check operation and re-
stores the system default settings.
[Factory Test]
Click [Start] to perform the factory test. The result of the test is shown on the display.
1-52
xx.xx.xxxx
xx.xx.xxxx
xx.xx.xxxx
0359266-
xx.xx.xxxx
xx.xx.xxxx
xx.xx.xxxx
xx.xx.xxxx