Table of Contents
Advertisement
3.
HUB-3000 IGMP Querier
Setup the IGMP querier function of HUB-3000 to connect the FAR-2xx7 series radar
to FAR-3000 series radar via HUB-3000.
Preparations
• PC with port RS-232C (D-SUB 9-pin connector)
• Cross cable RS-232C (D-SUB 9-pin connector)
• Software for serial device control (HyperTerminal, Tera Term or Putty etc.)
RS-232C cross cable
Pin (Female)
Procedure
This shows the procedure with Tera Term.
1. Connect the RS-232C cross cable to the serial port of the PC.
2. Connect the RS-232C cross cable to the serial port of HUB-3000.
Note: When disconnecting the RS-232C cross cable, disconnect it from the HUB-
3000 and then disconnect from PC.
3. Activate "Tera Term" on PC.
4. Check the radio button for [Serial] then select the appropriate COM port in [Port].
5. Click [OK].
Pin No.
Signal
1
NC
2
RD
3
SD
4
NC
5
SG
6
NC
7
NC
8
NC
9
NC
Frame
FG
COM Port (COM1)
Connection
3-1
Advertisement
Table of Contents
