Table of Contents
Advertisement
1. INITIAL SETTING AND ADJUSTMENT
1.3
[Own Ship Setting] Menu
Enter the information for ship parameters/CCRP, antenna unit, GPS sensor, AIS tran-
sponder, echo sounder (E/S), and SDME sensor. As for the symbol for sensors, there
are six colors to show the priority: white (CCRP), cyan (radar), green (GPS), magenta
(AIS), orange (E/S) and blue (SDME) in that order.
This setting is required when showing own ship and using the chart mode.
1. Access the [Common Installation Setting] menu and click [Own Ship Setting] on
the tab bar.
2. Activate each field and enter own ship's data, using the table below for reference.
Menu item/interactive field
[Vessel Type]
[Ship Length (LOA, m)]
[Ship Width (m)]
[Summer Load Line (m)]
[MAX ROT (deg/min)]
[Block Coefficient]
[Min Maneuvering Speed (kn)]
[Center of Gravity X(m), Y(m),
Z(m)]
[Pivot Point X(m), Y(m), Z(m)]
[CCRP X(m), Y(m), Z(m)]
1-12
Description
Own ship type among [Fast/Super Small], [Fast/
Small], [Slow/Big] and [Super Tanker].
Own ship's length, in meters.
Own ship's width, in meters.
Distance between own ship's hull and the sum-
mer load line, in meters.
Own ship's maximum angular velocity (Rate of
turn).
Own ship's block coefficient.
Minimum maneuvering speed.
Own ship's center of gravity, in meters, set by X,
Y and Z axis.
Own ship's pivot point, in meters, set by X, Y and
Z axis. Approximately 80% of the ship's length is
recommended for the pivot point. For example,
the ship's length is 350 m, enter "280 m" to [Y
(m)].
Select the [CCRP] you wish to setup by left-click-
ing the check box to the left of each CCRP num-
ber. You can set up a maximum of four CCRP
positions. Set up of [CCRP1] is required.
Advertisement
Table of Contents
