Table of Contents
Advertisement
2.3.1
How to activate the maintenance program
1. Turn off all sensor adapters.
2. Connect the applicable MC-3000S to the PC with the LAN cable.
3. Turn on the No. 6 of the DIP-SW (S10) on the MC-CS board (24P0114).
4. Turn on the sensor adapter MC-3000S.
5. The maintenance program activates after about 30 seconds. At this time, the IP
address of MC-3000S is changed to "172.31.17.108".
Confirm that the LED (CR 74) on the MC-CS board lights 3 times and goes off for
a while repeatedly.
2.3.2
How to confirm the firmware program version
1. Activate the maintenance program of the sensor adapter MC-3000S.
2. Activate the command prompt of Windows
3. Enter "telnet 172.31.17.108" on the command prompt.
Note: For Windows
tures][Turn Windows features on or off]. Put in the [Talent Client] menu then
click [OK].
4. Enter the user name and password correctly.
5. Enter "/usr/sbin/version" on the command prompt to confirm the program version.
The program version is shown on the command prompt.
Note: The image shown above is an example. The program version number may
be different.
6. After confirming the program version, enter "exit" to finish the telnet command.
®
7, select [Control Panel][Programs][Programs and Fea-
Enter the telnet command.
Enter the telnet command.
Enter the telnet command.
Enter the user name.
Enter the user name.
Enter the user name.
Enter the user password.
Enter the user password.
Enter the user password.
The command to confirm the program version.
The command to confirm the program version.
The command to confirm the program version.
After the confirmation the program version, enter "exit" .
After the confirmation the program version, enter "exit" .
After the confirmation the program version, enter "exit" .
2. SETTING FOR SENSOR ADAPTER
®
.
Boot program
Boot program
Boot program
Main program
Main program
Main program
Maintenance program
Maintenance program
Maintenance program
2-3
Advertisement
Table of Contents
