Using Key Operator Settings; Resetting The Adf Counter - Gestetner F104 Settings Manual

StellaF2_EN_Combine_F_FM.book Page 122 Friday, February 14, 2003 5:16 PM
Key Operator Settings

Using Key Operator Settings

The chapter explains about functions
the key operator handles.

Resetting the ADF Counter

You need to replace the ADF Mainte-
nance Kit when you are prompted to
do so by "
Replace ADF Mainte-
" message is displayed.
nance Kit
If you replace the ADF Maintenance
Kit when this message is displayed,
you do not need to reset the counter.
However, if you replace the ADF
Maintenance Kit when this message
is not displayed, you must follow the
procedure below to reset the counter.
Reference
See p.190 "Replacing the ADF
Maintenance Kit".
7
A A A A
Press the { { { { User Tools} } } } key.
B B B B
Press 0 0 0 0 or 1 1 1 1 until "2. Fax Fea-
tures" is displayed.
C C C C
Press the { { { { OK} } } } key.
D D D D
Press 0 0 0 0 or 1 1 1 1 until "4. Key Op.
Tools" is displayed.
E E E E
Press the { { { { OK} } } } key.
122
F F F F
Press { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } .
G G G G
Press the { { { { OK} } } } key.
Confirm that "1. ADF Counter Re-
set " is displayed.
H H H H
Press the { { { { OK} } } } key.
I I I I
Press 0 0 0 0 or 1 1 1 1 to select "Reset".
J J J J
Press the { { { { OK} } } } key.
K K K K
Press the { { { { User Tools} } } } key.
The standby display reappears.