Commands List - Gestetner DSm415 Network Manual

Appendix

Commands List

Use the "help" command to display
remote maintenance use.
Note
❒ Enter "help" to display a list of
commands that can be used.
msh> help
❒ Enter "help command_name" to
display information about the syn-
tax of that command.
msh> help command_name
TCP/IP address
Use the "ifconfig" command to con-
figure the Ethernet interface, the IEEE
1394 interface/IEEE 802.11b, and the
TCP/IP (IP address, subnet mask,
broadcast address, default gateway
address) for the machine.
❖ ❖ ❖ ❖ Reference
msh> ifconfig
❖ ❖ ❖ ❖ Configuration
msh> ifconfig interface_name
parameter address
9
Interface
name
ether
*2
ip1394
*3
wlan
*1
If you did not enter an interface
name, it will automatically be set to
the Ethernet interface.
*2
Available when the optional 1394
interface board is installed.
*3
You can specify an interface when
installing the optional 802.11b in-
terface kit.
90
Interface to be config-
ured
*1
Ethernet interface
IEEE 1394 interface
IEEE 802.11b interface
Parameter Meaning
(no parameter) IP address
netmask subnet mask
broadcast broadcast address
❖ ❖ ❖ ❖ Changing the Interface
You can specify either Ethernet in-
terface or IEEE 802.11b interface
when using the optional 802.11b
interface kit.
msh> ifconfig interface up
Note
❒ You cannot specify the optional
I E E E 1 3 9 4 i n t e r f a c e b o a r d
(ip1394).
The following is a sample configura-
t i o n , u s i n g a n I P a d d r e s s o f
192.168.15.16 on an Ethernet inter-
face:
m s h > i f c o n f i g
192.168.15.16
The following is a sample configura-
t i o n , u s i n g a s u b n e t m a s k o f
255.255.255.0 on an Ethernet inter-
face:
msh> ifconfig ether netmask
255.255.255.0
Note
❒ This affects the configuration of
the network interface board on the
IP address used.
❒ The TCP/IP setting is the same as
that of the Ethernet interface and
IEEE 802.11b interface.
❒ To enter an address using hexadec-
imal, prefix it with "0x".
e t h e r