Gestetner DSm415 Network Manual page 131

Message
smbd start. (NetBEUI)
Snmp over ip is ready.
Snmp over IP over 1394 is ready.
Snmp over ipx is ready.
snmpd start.
started.
The print server received error <error
number> during attempt to log in to the net-
work.Access to the network was denied.Verify
that the print server name and password are
correct.
SMTPC: failed to get smtp server ip-address.
SMTPC: failed to connect smtp server. timeout. Failed to connect the SMTP server due to
SMTPC: refused connect by smtp server.
SMTPC: no smtp server. connection close.
Causes and solutions
An smbd (SMB (Server Message Block) serv-
ice) has started.
Communication over TCP/IP via SNMP is
available.
Communication over IP over 1394 via SNMP
is available.
Communication over IPX via SNMP is availa-
ble.
SNMP service has started.
Direct print service has started.
Cannot log on to the file server. The print serv-
er is not registered or a password is specified.
Register the print server without specifying a
password.
Failed to get the SMTP server IP address. This
could be because:
• The DNS server could not be found.
• There is no connection to the network.
• The specified DNS server could not be con-
nected to.
• Incorrect DNS server is specified.
• No specified SMTP server IP address in
the DNS server.
timeout. This could be because:
• The SMTP server name is incorrect.
• There is no connection to the network.
• The network configuration is incorrect, so
there is no response from the SMTP server.
The connection to the SMTP server is denied.
This could be because:
• Another server other than the SMTP server
has been specified.
• The SMTP server port number is incorrect.
No response from the SMTP protocol. Cannot
connect to the SMTP server. This could be be-
cause:
• Another server other than the SMTP server
has been specified.
• The SMTP server port number is incorrect.
Message List
9
125