Single-Line Messages On The Display Panel; Messages Without Code Numbers - Gestetner DSm415 Network Manual

Single-line Messages on the Display Panel

This section describes the most common network-related messages that appear
on the display panel. If a message not described here appears, act according to
that message.

Messages without Code Numbers

Reference
Before turning the main power off, see "Turning On the Power", General Set-
tings Guide.
Message
Ethernet board has a problem. An error has occurred in the
IEEE1394 board has a prob-
lem.
Problems with IEEE1394
Board.
HDD has a problem.
IEEE 802.11b (Wireless LAN)
has a problem.
Cannot connect with the wire-
less card.
Problems with the wireless
card.
Problems with the wireless
board.
Causes
Ethernet board.
An error has occurred in the
IEEE 1394 board.
An error may have occurred
in the IEEE 1394 board.
An error has occurred in the
hard disk drive.
An error has occurred in the
IEEE 802.11b (wireless LAN)
board.
IEEE 802.11b card was not in-
serted when the machine was
turned on, or it was pulled out
after the machine turned on.
An error has occurred in the
IEEE 802.11b card.
An error has occurred in the
IEEE 802.11b card.
An error has occurred in the
IEEE 802.11b (wireless LAN)
board.
Single-line Messages on the Display Panel
Solutions
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Turn off the main power
switch, and check the card is
installed correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
9
107