Gestetner DSm415 Network Manual page 106

Appendix
msh> wins
WINS Configuration:
interface_name:
WINS: On
0.0.0.0
0.0.0.0
tion:
0.0.0.0
0.0.0.0
ScopeID
Note
❒ If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖ ❖ ❖ ❖ Configuration
Use the "set" command to make
WINS active or inactive.
msh> wins interface_name
{on | off}
• "on" means active; "off" means
inactive.
❖ ❖ ❖ ❖ Setting WINS Server Address
9
You can make settings for the
WINS server address.
msh> wins interface_name
{ p r i m a r y | s e c o n d a r y }
IP_address
• "primary" is for setting the pri-
mary WINS server address.
• "secondary" is for setting the
secondary WINS server ad-
dress.
❖ ❖ ❖ ❖ NBT scope ID setting
You can configure the NBT scope
ID.
Limitation
❒ Enter a scope ID using up to 31
alphanumeric characters.
100
primary server
secondary server
ScopeID
Current configura-
primary server
secondary server
hostname host_name
msh> wins interface name
scope scope ID
Note
❒ If you receive different scope
IDs from DHCP and WINS, the
scope ID from DHCP takes pri-
ority.
Interface name Interface to be configured
ether Ethernet interface
IEEE 802.11b interface
*1
wlan
IEEE 1394 interface
*2
ip1394
*1
Available when
802.11b interface kit is installed.
*2
Available when the optional 1394
interface board is installed.
AutoNet
Use the "autonet" command to config-
ure AutoNet settings.
❖ ❖ ❖ ❖ Display
The following command displays
the current AutoNet settings.
msh> autonet
❖ ❖ ❖ ❖ Configuration
You can configure the AutoNet
settings.
msh> autonet interface_name
[on|off]
Note
❒ Select [on] to enable AutoNet.
❒ Select [off] to disable AutoNet.
❖ ❖ ❖ ❖ Interface Priority Configuration
You can assign priorities govern-
ing which interface obtains Au-
toNet parameters.
m s h > a u t o n e t p r i o r i t y
interface_name
the optional