What to do If Something Goes Wrong
If You Cannot Make Copies as You Want
Problem
Copies are not sta-
pled.
3
Staples are wrongly
positioned.
Misfeeds occur fre-
quently.
You cannot combine
several functions.
Adjust Image
Problem
In Center/Border
mode, parts of the
original image are not
copied.
In Image Repeat
mode, the original im-
age is not copied re-
peatedly.
86
Cause
There are jammed staples in
the stapler.
The number of copies exceeds
the capacity of the stapler.
The stapler has run out of sta-
ple.
Originals are not set correctly. Set originals correctly. See
Copy paper size setting is not
correct.
Selected functions cannot be
used together.
Cause
The margin is too wide.
Your original has narrow
margins on four sides.
You selected the same size
copy paper as originals, and
did not select the proper re-
production ratio.
Action
Remove jammed staples. See
P.109 "e Removing Jammed
Staples".
Note
After removing jammed
staples or adding staples,
staples might not be eject-
ed the first few times you
try to use the stapler.
Check the stapler capacity.
See
P.38 "Staple".
Add staples. See
P.107 "d
Adding Staples".
P.38 "Staple".
Set the proper paper size. See
P.103 "Changing the Paper
Size".
Refer to the combination
chart. See
P.80 "Combina-
tion Chart".
Action
Set a narrower margin with
the user tools. See "01. Border
Erase Width" in
P.121 "2.
Adjust Image 1/3". See "02.
Center Erase Width" in
P.121 "2. Adjust Image 1/3".
Select copy paper larger than
the originals. See
P.72 "Re-
peat Image—Repeating an Image
over the Entire Copy".
Select the proper reproduc-
tion ratio. See
P.72 "Repeat
Image—Repeating an Image over
the Entire Copy".