ZyXEL Communications RGS Series User Manual page 120

MVR Name
IGMP Address
Mode
Tagging
Priority
LLQI
Interface Channel Profile
Profile Management
Button
Port
Port Role
Immediate Leave
120
MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 16. MVR VLAN Name can only
contain alphabets or numbers. When the optional MVR VLAN name is given, it should
contain at least one alphabet. MVR VLAN name can be edited for the existing MVR
VLAN entries or it can be added to the new entries.
Define the IPv4 address as source address used in IP header for
frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management address of the IP
interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available IPv4
management address.
Otherwise, system uses a pre-defined value. By default, this value will be 192.0.2.1.
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
membership reports on source ports. In Compatible mode, MVR membership reports
are forbidden on source ports. The default is Dynamic mode.
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged or
Tagged with MVR VID. The default is Tagged.
Specify how the traversed IGMP/MLD control frames will be sent in prioritized
manner. The default Priority is 0.
Define the maximum time to wait for IGMP/MLD report memberships on a receiver
port before removing the port from multicast group membership. The value is in units
of tenths of a second. The range is from 0 to 31744. The default LLQI is 5 tenths or
one-half second.
When the MVR VLAN is created, select the
condition for the specific MVR VLAN. Summary about the Interface Channel Profiling
(of the MVR VLAN) will be shown by clicking the view button. Profile selected for
designated interface channel is not allowed to have overlapped permit group address.
You can inspect the rules of the designated profile by using the following button:
: List the rules associated with the designated profile.
The logical port for the settings.
Configure an MVR port of the designated MVR VLAN as one of the following roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should only
receive multicast data. It does not receive data unless it becomes a member of the
multicast group by issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
Select the port role by clicking the Role symbol to switch the setting.
I indicates Inactive; S indicates Source; R indicates Receiver
The default Role is Inactive.
Enable the fast leave on the port.
Buttons
Click to add new MVR VLAN. Specify the VID and configure the new entry.
Click "Save".
Click to apply changes.
Click to undo any changes made locally and revert to previously saved values.
IGMP
IPMC Profile as the channel filtering
control