Troubleshooting Guide - Power Head Led - Genie 1022 User Manual

TROUBLESHOOTING GUIDE -
Power head LED
Red LED
showing
OFF
Continuous ON
1 BLINK, Pause
(Repeat)
1 BLINK, Pause
(Repeat)
2 BLINKS, Pause
(Repeat)
3 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
5 BLINKS, Pause
(Repeat)
26
POWER HEAD LED
Green LED Possible Problem
showing
OFF Normal operation
• Programming incomplete
• Transmitter has not learned
• Programming incomplete
• Safety Beam sensor
obstruction going down
• Door obstruction going down
• Door obstruction going up
• Programming incomplete
• Wire to power head or wire
connection at power head is
bad.
• Sensors out of alignment
• Continuous obstruction
• Limits set backwards
• Push button wire short
• Push button wires reversed
in power head connector.
• Chain is too tight
• Control system failure
• Thermal Protector activated
PN# 3642036212, 8/09/2007
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
None required
• Complete programming
• Push button to program
• Set DOWN LIMIT programming
• Check for obstruction, remove
• Check for obstruction, remove.
– Check door spring
– Contact The Genie Company at
1-800-35-GENIE
• Set UP LIMIT programming
• Check power head wiring, check
connections,
– Replace or repair
• Check Source & Sensor alignment
• Check for obstruction
• Clear limits and reprogram
(See section
• Check push button and wiring.
Staples can cut insulation and shorts
wires. Repair or replace push button
and/or wiring.
– Contact The Genie Company at
1-800-35-GENIE
• Reverse wire placement in power
head connector. (See section
• Adjust chain tension (See section
– Contact The Genie Company at
1-800-35-GENIE
• Contact factory authorized dealer for
service
• Wait until Thermal Protector cools
and resets. NOTE: The 5 BLINKS
pattern will remain blinking until
the next operator activation. If the
Thermal Protector does not reset.
– Contact factory authorized dealer
for service.
Solution
)
6
)
3
).
1