Remote Control Operation; Erase Remotes From Power Head Memory; To Replace Remote Controm Battery; Install Light Bulbs/Lens - Genie 4560 Operation & Maintenance Manual

Remote Control
Operation
A Press Button on Remote Control. Garage door will move.
B Press Button again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
C Press Button again. Garage door will reverse.
1 Button Compact Remote
w/Docking Station
Figure MA-I Genie Remote Controls
Figure MA-2 Learn Code Button and Indicator Light
To Erase All Remotes from Power Head Memory
A Pressand hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out.
Memory is erased:
Program Transmitter/Receiver again as needed.
To
Replace
Remote Controm
Battery
A FORNON-FLASHMGHTMODELS (Figure MA-S)
, Pop off the back of the transmitter.
- Use coin, pen, screwdriver or any similar device.
- Replace old Battery with new coin type battery.
Replace back of remote.
Figure MA-3 Pry case open at the notch
FORFLASHLIGHTMODELS
Pry open battery cover, (Notch built into cover,)
- Replace old Battery with new AAA battery,
Snap shut battery cover,
Toprogram a Homefink ®or Car2UDevice:
® (This GDOis Home/ink and Car2U compatible)
• Fotlowthe Homelink <_ o r Car2Uinstructionsin yourcar
owner'smanual.
le included _ener: A
walt consolecancausethe Openerto operate unexpecb
edly and the light to stop working,
NSTALL LIGHT
BULBS AND
LENS
Snap Lens Hinqes into _
slots on back of Motor Cover
60 Watts
........ maximum
Lens
@
Figure MA-4 Install Lens Cover and Light
Bulbs
A Installtwo 60 Watt light bulbs (not included) into Light
Sockets(Figure MA-4):
° Roughservice,130Volt bulbs are recommended.
B Install Lensinto slots in Motor Cover.
C Install GenieEmergencyRelease Kit (GER-2)accessory,
if purchased.
D Installation is now comp]ete.
Push in
Latches
to
close Lens
For He_p, call 1-800-35-GENIE or visit www.geniecompany.com 9