Troubleshooting Guide - Power Head Led - Genie 2022 Manual

TROUBLESHOOTING GUIDE -
Power head LED
Red LED
showing
OFF
Continuous ON
1 BLINK, Pause
(Repeat)
1 BLINK, Pause
(Repeat)
2 BLINKS, Pause
(Repeat)
3 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
5 BLINKS, Pause
(Repeat)
28
POWER HEAD LED
Green LED
Possible Problem
showing
OFF Normal operation
• Programming incomplete
• Transmitter has not learned
• Limit Programming incomplete
• Safe-T-Beam
obstruction going down
• Door obstruction going down
• Door obstruction going up
• Limit Programming incomplete
• Wire to power head or wire
connection at power head is
bad.
• Sensors out of alignment
• Continuous obstruction of
Safe-T-Beam
• Limits set backwards
• Wall button wire short
• Wall button wires reversed
in power head connector.
• Chain/belt is too tight
• Control system failure
PN# 37026500123
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
None required
• Complete programming
• Push transmitter button to program
(See section
• Set DOWN LIMIT programming
sensor • Check for obstruction, remove
®
• Check for obstruction, remove.
– Check door spring (See section
– Contact The Genie Company at
1-800-35-GENIE
• Set UP LIMIT programming
• Check power head wiring, check
connections,
– Replace or repair
• Check Source & Sensor alignment
• Check for obstruction of
sensor Safe-T-Beam
®
• Clear limits and reprogram
(See section
• Check button(s) and wiring.
Staples can cut insulation and shorts
wires. Replace Wall Control, repair or
replace wiring.
– Contact The Genie Company at
1-800-35-GENIE
• Reverse wire placement in power
head connector. (See section
• Adjust chain/belt tension
(See section
– Contact The Genie Company at
1-800-35-GENIE
• Contact Genie
service
05/15/2009
Solution
)
7
)
10
sensor
®
)
6
)
3
).
1
authorized dealer for
®