Configuration Port - Extron electronics DXP DVI Pro User Manual

Configuration Port
c
Control Buttons
Primary Functions
Action:
Indication: Blink: Save needed
Secondary Functions
Action/
I/O Grouping
indication:
Action 1:
Port
Action 2/
configuration
indication:
Front panel
Action:
locks
d
Secondary functions ( ):
Select a global preset (see
Output 1 only:
mode (see "I/O Grouping" on page 28).
Mute and unmute an output (see
Outputs" on page 34).
Config port — This RS-232 port is an alternative to the Remote RS232/RS422
connector on the DXP rear panel (see
port (RS-232 only) can be used for system configuration and control via SIS commands
or the control software. To connect to the Config port, see
Remote Connections" on page 10.
The following table summarizes the primary and secondary functions of the four
control buttons.
ENTER
Save changes. Select preset mode. Select view mode. Cancel or escape.
Blink: Save preset.
Lit: Recall preset.
Select group 1. Select group 2.
Select Configuration Mode
Select 9600 baud. Select 19200 baud.
Blink: Selected Blink: Selected
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
Enter button
Primary functions (❏):
❏
Saves changes that you make on the front panel.
❏
Indicates that a potential tie has been created but not saved.
❏
Indicates that a global preset has been selected to be saved or recalled but that
the preset action has not been accomplished.
"Saving and Recalling Presets" on page 32).
"Muting and Unmuting Video and Audio
"Rear Panels" on page 6 for a description). The
PRESET
VIEW
mode.
Select group 3.
Select 38400
baud.
Blink: Selected
"RS-232 and RS-422
ESC
Flashes once.
Select group 4.
Select 115200
baud.
Blink: Selected
14