Table of Contents
Advertisement
Additional printer setup
6
Reattach the access cover.
7
Tighten the screws on the access cover.
8
Reattach the connector cover.
Installing a memory card
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them off as well, and unplug any cables going into the printer.
1
Access the controller board.
For more information, see
2
Unpack the memory card.
Warning—Potential Damage: Do not touch the connection points along the edge of the card. Doing so
may cause damage.
3
Align the notch (1) on the memory card with the ridge (2) on the connector.
"Accessing the controller board" on page
21.
24
Advertisement
Table of Contents
