Section 1 - Quick Set-Up - Electro-Voice REV Operating Instructions Manual

Section 1 - Quick Set-Up

Quick Set-up: Receiver
1. Do not connect the receiver to any other equipment yet!
2. Connect the two Antennas to the receiver.
3. Plug the power cord into the back of the receiver and into
an outlet.
4. Press the Power switch. Display will light up, show EV
name and software revision numbers for about 3 seconds
and then display the main operating screen.
5. Press the MENU button twice to display the MENU option
screen and then press set.
6. With the CLEARSCAN ALL line highlighted, press SET.
TM
7. ClearScan returns the clearest group. Press SET again.
8. ClearScan returns the clearest channel in that group.
Press SET again.
9. The display will return to the main operating screen with the
clearest channel in the clearest group assigned.
10. Turn the receiver off and connect the mixer or other audio
system to the receiver XLR Mic/Line Level Connector or the
1/4 inch Line Level Jack.
11. Set the audio mixer or other system input level to minimum.
12. Turn receiver back on.
Receiver "Quick Set-up" is complete.
Quick set-up: Transmitter
1. With the Power switch on the transmitter OFF, install a fresh
Battery (9V or two AA) into the transmitter.
2. Place the transmitter Power Switch to the ON position.
3. The LCD display backlight will come on and display Group
and Channel and battery level.
4. Press the SET button once and the Group number will
flash.
5. Use the up and down arrows to change the Group number
to match the channel number displayed on the receiver.
Press SET and the Channel Number will flash.
6. Use the up and down arrow buttons to change the Channel
to match the receiver. Press Set and nothing will be flash-
ing, the channel is now set.
7. If you are using a bodypack transmitter, plug the micro-
phone into the transmitter connector. If using a quitar, put
the bodypack and receiver into instrument mode (see page
5, Part K and page 13, Part G).
Transmitter "Quick Set-up" is complete.
Quick set-up: System Operation
1. With the transmitter and receiver on, monitor the REV
Receiver main display screen. Note that the RF (1-100) Bar
graph should indicate near the 100 mark. The AF Bar
should show very little if any, indication until you talk or sing
into the microphone.
2. On the transmitter, press Set and Down buttons at the
same time twice to access the gain adjustment mode.
3. Press set and use the Up and Down buttons to adjust the
transmitter gain to cause the AF Bar Graph to peak
between 50 and 100 for best performance.
4. Set the mixer/amp gain.
5. Talk or sing into the microphone or play the guitar at a nor-
mal volume. You should hear audio coming out of the sys-
tem.
6. If you are not getting enough level at the input of the mixer,
see the audio output gain adjustment section on page 5.
"Quick Set-up" is now complete. Please enjoy your
REV system.
-1-
ENGLISH