Table of Contents
Advertisement
ENGLISH
Table of Contents
3. Detailed system/component setup instructions
3.3 Beltpack Setup
8. Components & Accessories
1. Quick System Setup Guide
Receiver Setup
1. Plug power supply cord into the back of the receiv-
er and plug the power supply into an outlet. The
channel display & red/green "Diversity" light on the
receiver front panel should light up.
2. Depress "SET" button on front panel and release
when channel display starts to flash (about 3
seconds). This activates "ClearScan
interference free channel for operation. Note the
channel (0 - 9) shown on the receiver front panel
channel display.
3. Connect receiver audio output to mixer (or
amplifier if using guitar system). Mute or reduce
mixer/amp gain.
4. Orient receiver antennas angled up and away from
each other (at a 90 degree angle).
Transmitter Setup
1. Open battery compartment, install 9 Volt battery.
Make sure to observe proper battery polarity.
2. Adjust channel setting to match channel number
shown on receiver channel display. Replace
battery cover.
3. If using beltpack transmitter, plug the microphone
into the transmitter connector. If using guitar
system, connect
TM
" to find an
1
/
" plug into guitar.
4
Operating the system
1. Turn transmitter ON via the ON/OFF switch.
Yellow "Tx On" light should illuminate on the receiv-
er front panel.
2. Turn audio switch to the ON position to unmute the
audio.
3. Set mixer/amp gain to normal position.
4. Talk/sing into the microphone or play the guitar at a
normal volume. You should hear audio coming out
of the system.
5. If the signal is distorted, turn the gain adjust con-
trol on the transmitter down. If the signal level is
low, you may need to turn the gain adjust control
up.
6. If connected to the receiver
front panel, adjust gain (via the control next to the
connector) to correspond to the signal level found
when singing or playing through a wired system.
1
/
" output jack on the
4
Hide quick links:
Advertisement
Table of Contents
