Electro-Voice REV Operating Instructions Manual page 9

12 Volt Power On "Antenna In" Jacks
To power in line antenna amplifiers, 12 volt power is available on
the center pin of the antenna in jacks. This power is disabled
when the REV leaves the factory but may be turned on by the
installer.
To turn on the 12 volts, first take off the cover of the radio by
removing 14 screws. There is a 2 pin "header" and a "jumper"
behind the "XLR" audio connector on each of the two large print-
ed circuit boards. See Figure 5. The jumper is installed on one
pin of the header at the factory. To turn on power, unplug the
jumper and install it on both pins of the header.
CAUTION: Do not attach antennas and splitters with a DC short
circuit to the antenna in jacks when the power is turned on.
Damage could result to the splitter or receiver.
The following antennas and accessories may be used with
power on:
FA-1, CLA-X, APD4+, APD4-1+, UAA-50
The following antennas and accessories may be used with the
power off:
FA-1, CLA-X, LPA-500, APD4, APD4-1
Power Enabled
REV-LINK PC Software
1. Software to monitor and control the REV receivers from a
PC through the USB port and a UCC-1 is available at
www.electrovoice.com. Minimum system requirements
are:
Windows 2000
512 Mbytes of RAM
One USB port
UCC-1 or N8000
CD-ROM Drive
2 Mbytes of hard drive memory
Figure 5
Moving Jumper
(Be sure to move Jumper on Both
Receiver printed circuit boards.)
-7-
Power Disabled
ENGLISH