Headphone Operation; Antenna Connections - Electro-Voice REV Operating Instructions Manual

Headphone Operation

1. With the transmitters and receivers setup and operating,
plug stereo headphones into the 1/4 inch jack on the front
panel.
2. The Selected Receiver LED will indicate receiver 1 is being
monitored. Press the Receiver Select button once to
change from Receiver 1 to 2.
3. Press the Receiver Select button once more and both indi-
cator LEDs will light. You can now listen to both receivers.
NOTE: if both receivers are set to the same channel, the
volume will double.
4. Pressing the Select button once more cycles back to
Receiver 1.

Antenna Connections

1. Install the two 1/2 wave antennas to the "antenna in" jacks
on the rear panel.
NOTE: The two 1/2 wave antennas included with the REV can
be remote mounted. For an additional 5dB gain use the LPA500
log periodic directional antenna.
2. The REV-DUAL is equipped with a left and right antenna
output jack. These jacks can be used to connect up to 3
REV-DUAL (6 receivers) to two antennas without any addi-
tional equipment. DO NOT remove "dummy" loads unless
connecting to another receiver.
3. Figure 3 shows the connection diagram for 3 REV-DUAL
units.
4. UP to 12 REV-DUAL units can be operated with just two
antennas with the optional APD4+ antenna distribution unit
(see Figure 4).
Antenna Chaining
Figure 3
Antenna Chain with APD4-B
-6-
ENGLISH
Figure 4