Electro-Voice REV Operating Instructions Manual page 18

K. Change Lock-Out - Disables the SET button
to protect settings
1. To engage change Lock press and hold the UP arrow key
about four seconds until SECURE appears in the display.
2. To remove the Change Lock, press and hold the UP key
until ACCESS appears in the display.
L. No RF Operation
During a show or setup it is sometimes desired to turn on a
transmitter without the RF carrier to check the channel, assign
a new channel or check battery levels.
1. Press and hold the DOWN button when you turn the
power switch on and tr OFF will be displayed.
2. All setup functions will work but there will be no RF carri-
er or audio
The tr OFF mode is a one time operation, the next time the unit
is turned on it will be in normal operation mode.
M. Master Reset
To return the transmitter to factory default settings and erase all
user defined frequencies press and hold the MENU and DOWN
keys at the same time for 8 seconds.
N. Verify reception
1. With the transmitter and receiver on and matching Group
and Channel, the main receiver display should be indicat-
ing an RF signal on the bar graph.
2. Speak into the microphone and the Audio Meter bar
graph should indicate audio signal presence
3. If the level meters do not show reception, make certain
the group and channel are matching and refer to the trou-
ble shooting section.
4. Go back to Section 3.1 - (Receiver Setup & Operation
Step 1) to complete system set up and test
-16-
ENGLISH