Add/Edit Policy Route - ZyXEL Communications VMG3925-B10A User Manual

9.4.1 Add/Edit Policy Route

Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use
this screen to configure the required information for a policy route.
Figure 65 Network Setting > Routing > Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 43 Network Setting > Routing > Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source
Interface
WAN Interface
OK
Cancel
Chapter 9 Routing
DESCRIPTION
Select Enable to activate this policy route.
Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
VMG3925-B10A User's Guide
137