Add/Edit A Qos Shaper; Qos Policer Setup - ZyXEL Communications EX3510-B0 User Manual

10.6.1 Add/Edit a QoS Shaper

Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the following
screen.
Figure 91 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
Table 51 Shaper Setup: Add/Edit
LABEL
Active
Interface
Rate Limit
Cancel
OK

10.7 QoS Policer Setup

Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic and
apply actions, such as drop, pass, or modify, to the DSCP value of matched traffic. Click Network Setting
> QoS > Policer Setup. The screen appears as shown.
Figure 92 Network Setting > QoS > Policer Setup
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Click this switch to enable or disable the shaper. When the switch turns blue
enabled. Otherwise, it is not.
Select a Zyxel Device interface through which traffic in this shaper applies.
Enter the average rate limit of traffic bursts for this shaper.
Click Cancel to exit this screen without saving any changes.
Click OK to save your changes.
EX3510-B0 User's Guide
157
, the function is