Table of Contents
Advertisement
SHIP'S SPD/BR
Choose the source of speed and course data with which to draw ship's track.
1. Rotate the [RANGE] control to select SHIP'S SPD/BR.
2. Rotate the [GAIN] control to choose item appropriately.
LOG/GYRO:
Use data from the speed log connected to LOG port as ship's
speed, data from gyrocompass connected to GYRO port as ship's
course.
CURRENT:
Use data from the current indicator connected to NMEA1/CIF1 or
NMEA2/CIF2 port.
NAV DATA:
Use data from the equipment (set at [NAV DATA] described on
next page) connected to NMEA1/CIF1 or NMEA2/CIF2 port.
GYRO+NAV:
Use heading data signal from the sensor connected to GYRO port
for course, data from the equipment (set at [NAV DATA] described
on next page) or current indicator connected to NMEA1/CIF1 or
NMEA2/CIF2 port for the ship's speed. When using data from the
current indicator (for positioning) for ship's speed, set DIP switch
#2-2 in the transceiver unit to ON.
LOG PULSE
Choose log pulse/mile specification of speed signal from the LOG port, 200 or 400
pulse/mile.
1. Rotate the [RANGE] control to select LOG PULSE.
2. Rotate the [GAIN] control to choose 200 or 400.
PORT 1 BAUDRATE, PORT 2 BAUDRATE
Set baud rate of equipment connected to NMEA1/CIF1 or NMEA2/CIF2 port, among
2400, 4800, 9600 and 19200 (bps).
1. Rotate the [RANGE] control to select PORT 1 BAUDRATE or PORT 2 BAU-
DRATE.
2. Rotate the [GAIN] control to choose item among 2400,4800, 9600 and 19200.
MAIN Board
S2
S3
Location of DIP switch S3
3. ADJUSTMENT
3-5
Advertisement
Table of Contents
