Table of Contents
Advertisement
1. MOUNTING
4. Fasten the KB fixing plate with two tapping screws ( 6.5, local supply).
Installation without KB fixing plate
1. Make four holes of 6 mm in diameter referring to the figure below.
2. Make an indentation in the desktop to accommodate the nameplate (approx. 2
mm thickness) at the bottom of the control unit.
3. If necessary, make a hole 30 mm in diameter in the tabletop to pass the control
cable from the bottom of the control unit. To run the able from the bottom of the
control unit, see the next page.
4. Screw in four hex. bolts (M5 12, supplied as accessories) from the under side of
the table to fix the control unit.
When the above bolts are not long enough, use locally supplied bolts, with their
length the thickness of the desktop plus 5 to 8 mm.
1-14
300±1
How to attach KB fixing plate
300±1
Control unit, dimensions for directly mounting
Mounting control unit directly
Hex. bolt
(M5×12)
Tapping screw
(Fixing hole: ø6.5)
Fixing hole ø6
Cable
KB fixing metal
75±1
Advertisement
Table of Contents
