Table of Contents
Advertisement
3. Coat the top of the main shaft with a small amount of grease. Pass the main shaft
through the main body flange, and fix it temporarily with the shaft retainer. (The
shaft retainer should be secure enough to prevent shaft rotation.)
Main shaft
Raise/lower drive assembly
Passing main shaft through the raise/lower drive assy.
4. Tape the end of the transducer cable with vinyl tape to pass the cable through the
main shaft. Remove sheath of transducer cable by the length shown below with
roller knife.
Note: Care should be taken not to damage inner wires when cutting the cable
sheath, only paper tape exists between the cable sheath and inner wires.
Lower edge of flange
M10 spring washer
Wipe-off grease before
tightening shaft retainer.
L
Main shaft length + 120 mm
Use suitable roller knife to cut sheath.
Transducer cable
Coat threads with grease.
M10×40
M10
15 mm
Main shaft should protrude
by 15 mm from top of the
shaft retainer.
1. MOUNTING
1-5
Advertisement
Table of Contents
