Table of Contents
Advertisement
8. Install grease cotton on the main body as below.
a) Wind grease cotton onto main shaft.
b) Mark on the cotton as below.
c) Remove the cotton from the shaft, and then cut it at the position of the mark.
Discard the ends.
d) Wind grease cotton as shown below.
e) Push grease cotton into the main body flange.
f) Tighten the grease cotton retainer.
9. Attach the tank guide.
Bow mark
Mounting location for tank
Position joints of cotton 120° apart and
push them into main body flange.
Flat washer
Setting grease cotton
Tank guide
M10
Align with bow mark on transducer.
Spring
M10×55
washer
TX frequency
*: Measure between the topof the transducer flange
and inneredge of the tank guide.
Installing the tank guide
1. MOUNTING
Tighten grease cotton retainer
for a gap of 7 to 9 mm.
Travel type
600
312 mm
107 kHz
288 mm
85 kHz
400
112 mm
88 mm
1-7
Advertisement
Table of Contents
