[Initial Start Up]; [Projection Method]; [Lamp Power]; [All] - Panasonic PT-VZ585N Operating Instructions Manual

Commercial use
Table of Contents

Advertisement

2)
Press the <ENTER> button.
f The [PROJECTOR ID] screen is displayed.
3)
Press as to select a projector ID.
f To select one item among [ALL] and [1] ~ [6].

[ALL]

[1] ~ [6]
4)
Press the <ENTER> button.
f [PROJECTOR ID] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], you cannot control a projector separately by specifying a different ID
number.
f Refer to "Setting the ID number on the remote control" (

[INITIAL START UP]

Set the startup method when the projector is switched on after connecting the power plug to outlet .
1)
Press as to select [INITIAL START UP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.

[LAST MEMORY]

[STANDBY]
[ON]

[PROJECTION METHOD]

Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1)
Press as to select [PROJECTION METHOD].
2)
Press qw to switch the projection method.
f The items will switch each time you press the button.

[AUTO]

[FRONT/DESK]
[FRONT/CEILING]
[REAR/DESK]
[REAR/CEILING]
Note
f Refer to "Angle sensor" (x page 34) for details on the range of the installation attitude that can be detected by the built-in angle sensor.

[LAMP POWER]

Switch the luminance of the luminous lamp according to the operating environment of the projector or the
purpose.
1)
Press as to select [LAMP POWER].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
88 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Select when controlling projectors without specifying an ID number.
Select when specifying an ID number to control individual projector.
Æ
page 59) for how to set the ID number on the remote control.
Starts up in the status that before removing the power plug from the outlet or turning off the circuit
breaker.
Starts up in the standby mode.
Starts the projection immediately.
Detects the projector's posture with built-in angle sensor, then switches to [FRONT/DESK] or [FRONT/
CEILING]. Usually it is set to [AUTO] when projecting in front of the screen..
When installing the projector on the desk, etc., in front of the screen.
When installing the projector in front of the screen with the Ceiling Mount Bracket (optional).
When installing the projector on the desk, etc., behind the screen (with a translucent screen).
When installing the projector behind the screen (with a translucent screen) with the Ceiling Mount
Bracket (optional).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-vw545nPt-vx615nPt-vz585nu

Table of Contents