[Projector Name]; [Network Control] - Panasonic PT-VZ585N Operating Instructions Manual

[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
8) After the setting, select [OK] and press the <ENTER> button.
Note
f For the setting of each item, contact your network administrator.
f If you use EAP, settings of the projector need to be configured according to the RADIUS server settings. Consult your network administrator
for the RADIUS server settings.
f If you use EAP together with an access point where SSID broadcast is disabled, select [WPA-EAP] or [WPA2-EAP] for authentication
method even when the authentication of the access point is WPA-EAP/WPA2-EAP.
f Wired LAN and wireless LAN cannot be used in the same segment.
f When using the projector with [DHCP] set to [ON], confirm that the DHCP server is running.
f If wireless LAN connection cannot be made via the access point even after executing "Projector settings" (
manufacturer of your access point (radio repeater).
f If [USER] is used, you cannot connect to the access point of stealth SSID configuration, please use it to cancel the stealth setting. For
details, refer to the Operating Instructions of the access point.
r Factory default settings
f Following setting has been made as a factory default.
[AUTHENTICATION]
[ENCRYPTION]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]

[PROJECTOR NAME]

You can change the projector name. Enter the host name if it is required to use a DHCP server.
1) Press as to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f The [PROJECTOR NAME CHANGE] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f You can enter up to eight characters.
4) After entering the projector name, press as to select [OK] and press the <ENTER> button.
Note
f The factory default setting of the projector name is "Namexxxx". xxxx stands for the last four-digit number of the network ID. The network
ID is a fixed value assigned to each projector. The network ID can be checked on the idle screen projected when switching to Panasonic
APPLICATION input.

[NETWORK CONTROL]

Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
Chapter 4 Settings - [NETWORK/USB] menu
[OFF]
[ON]
Enter the IP address when [DHCP] is set to [OFF].
Enter the subnet mask when [DHCP] is set to [OFF].
Enter the default gateway address when [DHCP] is set to [OFF].
Enter the preferred DNS server address when [DHCP] is set to [OFF].
Enter the alternate DNS server address when [DHCP] is set to [OFF].
[OPEN]
[NONE]
[OFF]
192.168.11.100
255.255.255.0
192.168.11.1
(Blank)
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
Æ
page 112), consult the
ENGLISH - 103