[Digital Link Menu]; [Wired Lan] - Panasonic PT-VZ585N Operating Instructions Manual

[DIGITAL LINK MENU]

When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected
to the <DIGITAL LINK/LAN> terminal, the main menu of the connected DIGITAL LINK output supported device is
displayed. Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.
Note
f [DIGITAL LINK MENU] cannot be selected when the [NETWORK/USB] menu → [NETWORK CONTROL] → [EXTRON XTP] is set to [ON].

[WIRED LAN]

Perform the connection settings to use wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
3) Press asqw to select an item, and change the setting according to the menu operation instructions.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
[EAP]
[USER NAME]
[PASSWORD]
4) After the setting, select [OK] and press the <ENTER> button.
Note
f For the setting content of each item, consult your network administrator.
f If you use EAP, settings of the projector need to be configured according to the RADIUS server settings. Consult your network administrator
for the RADIUS server settings.
f Wired LAN and wireless LAN cannot be used in the same segment.
f When using the projector with [DHCP] set to [ON], confirm that the DHCP server is running.
r Factory default settings
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]
[EAP]
Chapter 4 Settings - [NETWORK/USB] menu
[ON]
[OFF]
Enter the IP address when [DHCP] is set to [OFF].
Enter the subnet mask when [DHCP] is set to [OFF].
Enter the default gateway address when [DHCP] is set to [OFF].
Enter the preferred DNS server address when [DHCP] is set to [OFF].
Enter the alternate DNS server address when [DHCP] is set to [OFF].
Select the EAP setup in the RADIUS server. If EAP is not setup, set it to [NONE].
The types of EAP that can be selected are as follows.
[PEAP(MS-CHAPv2)], [PEAP(GTC)], [EAP-TTLS(MD5)], [EAP-TTLS(MS-CHAPv2)],
[EAP-FAST(MS-CHAPv2)], [EAP-FAST(GTC)]
Enter a user name with alphanumerics (excluding spaces) for authentication (maximum 64 characters).
It can be set when [EAP] is set to other than [NONE].
Enter a password with alphanumerics (excluding spaces) for authentication (maximum 64
characters).
It can be set when [EAP] is set to other than [NONE].
[OFF]
192.168.10.100
255.255.255.0
192.168.10.1
(Blank)
[NONE]
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.
ENGLISH - 99