Removing The High-Voltage Power Supply Pcb; Sub High-Voltage Power Supply Pcb; Preparation For Removing The Sub High-Voltage Power Supply Pcb - Canon LBP5000 Series Service Manual

Chapter 3
1) Remove the delivery tray. (page 3-7)Reference[Removing the Delivery
Tray]
2) Remove the rear cover. (page 3-2)Reference[Removing the Rear Cover]
3) Remove the right cover/right
3)Reference[Removing the Right Cover/Right Cassette Cover]
4) Remove the upper cover. (page 3-5)Reference[Removing the Upper
Cover]
5) Remove the left cover/left
4)Reference[Removing the Left Cover/Left Cassette Cover]

3.2.16.4 Removing the High-Voltage Power Supply PCB

LBP5000
1) Remove the high-voltage power supply PCB [1].
- 6 connectors [2]
- 1 washer [3]
- 3 screws [4]
- 3 claws
When mounting the high-voltage power PCB, check if the springs [2] can be
seen through the peephole of spring contact point [1]. If not, be sure to install
the PCB again so that the springs can be seen.
3-20
cassette cover.
(page
cassette cover.
(page
F-3-136
F-3-137
F-3-138
F-3-139
3-
3-
0010-7248

3.2.17 Sub High-Voltage Power Supply PCB

3.2.17.1 Preparation for Removing the Sub High-Voltage
Power Supply PCB
LBP5100
1) Remove the delivery tray. (page 3-7)Reference [Removing the Delivery
Tray]
2) Detach the rear cover. (page 3-2)Reference [Removing the Rear Cover]
3) Detach the right cover. (page 3-2)Reference [Removing the Right Cover
/ Right Cassette Cover]
4) Detach the upper cover. (page 3-5)Reference [Removing the Upper
Cover]
5) Detach the left cover. (page 3-4)Reference [Removing the Left Cover /
Left Cassette Cover]
6) Remove the high-voltage power supply PCB. (page 3-19)Reference

[Removing the High-Voltage Power Supply PCB]

F-3-140
[2]
F-3-141
F-3-142
[2]
F-3-143
0015-7618